Proface APL3000B - Node Box PC Uživatelský manuál stáhnout pdf (Strana 26)

Chapter 2 System Setup

2-5

 IDE Master / IDE Slave / SATA Port

Point out the cursor at the [Primary Master], [Primary Slave], [Secondary Master], or [Secondary Slave] on

the “Main screen”, and then press the [Enter] key, so that the following screen is shown.

Type

Specifies a type of drive which you use. Select from [Auto], [None], [ATAPI Removable], [CD-ROM],

[IDE-Removable], [Other ATAPI], or [User]. The factory default type is [Auto].

Total Sectors

Shows the number of disk sectors connected to the unit.

Maximum Capacity

Shows the maximum capacity of the disk connected to the unit.

Multi Sector Transfers

Specifies the number of sectors per block, which are transferred to the memory. When the [Type] is [None],

nothing is displayed. When [Type] is [Auto], the selection is disabled. In other cases, select from [Disabled],

[2 Sectors], [4 Sectors], [8 Sectors], or [16 Sectors].

LBA Mode Control

Enables or disables the Logical Block Address (LBA) instead of the Cylinders, Headers, and Sectors. When

the [Type] is [None], nothing is displayed. When [Type] is [Auto], the selection is disabled. In other cases,

select from [Disabled] or [Enabled].

32 Bit I/O

Specifies an enabled/disabled state for the 32 bit transferring between CPU and IDE controller. Select from

[Enabled] or [Disabled]. When the [Type] is [None], nothing is displayed.

• Select [Auto] to have the PS-A recognize the hardware properly.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 106 107

Žádné komentáře

Proface APL3000B - Node Box PC Uživatelský manuál Strana 26