Proface APL3000B - Node Box PC Uživatelský manuál stáhnout pdf (Strana 91)

PS-3710A/PS-3711A Series Hardware Manual

3-24

(4) After inserting all three pins, insert the Power Plug into the Power Connector at PS-A. Fix the plug with

two (2) slot screws.

 DC Power Supply Type Connections

 When connecting to PS-3710A Series Power Supply type

Power Cord Specifications

Wiring

When connecting the power cord, use the following items when performing wiring. (Items are made by

Phoenix Contact.

)

*1 For details, please contact your local Phoenix Contact distributor.

• Confirm that all wires are connected correctly.

• The torque required to tighten these screws is 0.5 to 0.6N•m.

• To prevent the possibility of a terminal short, use a pin terminal that has an

insulating sleeve.

Power Cord Diameter

0.75 to 2.5mm

(18 to 12 AWG)

Conductor Type Simple or Stranded Wire

*1 If the Conductor’s end (individual) wires are not twisted correctly, the end

wires may either short against each other, or against an electrode.

Conductor Length

• Use copper conductors only.

Recommended Driver SZS 0.6x3.5 (1205053)

Recommended Pin Terminals

AI 0.75-10GY (3201288)

AI 1-10RD (3200182)

AI 1.5-10BK (3200195)

AI 2.5-12BU (3200962)

Recommended Pin Terminal Crimp Tool CRIMPFOX ZA3 (1201882)

• The power supply connector (plug) is CA7-DCCNL-01 from Pro-face, or GFKC2,5/3-

STF-7,62 (made by Phoenix Contact

10mm[0.39in.]

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 110 111

Žádné komentáře

Proface APL3000B - Node Box PC Uživatelský manuál Strana 91